Preparation and further leveling of walls
We will begin to align with preparation. It is necessary to clean the wall, repel everything that is poorly held, and primer the surface. If this is necessary, then primed both the entire surface and its individual parts with Betokontakt soil. Then, using the rule, you need to measure all the adjoining. Juits include angles, approaches to door and window slopes, adjoining the ceiling and floor. Just all this needs to be pulled out and do as it can be as possible.
When measured by the wall, it will be more correct to mark on it, where you should apply a larger amount of plaster, and where less. Here it is also necessary to note the irregularities on the entire wall. All necessary preparations are completed and you can proceed to the level of alignment. The plaster is applied to the angle, which is aligned by the rule in the flat line, and after that, the spatula needs to stretch the plaster on the wall. When the plaster is completely dry, you can start putty. You can put up the wall completely or areas.