The second 7 stages of installation of metal -plastic windows
7. The window will be reliably on the top mount. Plus, you can adjust the level of inclination of the structure. To align the window, special wedges should be used. But just be careful, since excessive grinning can lead to the storm of rations can burst.
8. After the design is set in level, you can begin to fasten the side plates.
9. Now you need to pierce the windows. It should be borne in mind that the gap between the wall and the frame should not exceed two centimeters. Evenly distribute the mounting foam around the entire perimeter. You should not use a lot of foam, since it expand several times.
10. Installation foam not only acts as isolation, but also as a structure. If a certain amount of foam begins to go out, then do not try to stuff it back, this will not lead to anything good. If you do not have enough foam, it is better to use a new cylinder, as missing places will lead to the formation of drafts.
11. Then monitor the ebb from the outside with ordinary screws. And the junction of the profile with the tint needs to be anointed with silicone.
12. Install double -glazed windows in your place.
13. After that, close the wings, and if possible do not open them within two days.